1
General Information
i.
Copyright
The entire contents of this instruction manual, including any future updates, revisions, and
modifications, shall remain the property of AMEC at all times. Unauthorized copies or
reproduction of this manual, either in part or whole, in any form of print and electronic media, is
prohibited. The contents herein can only be used for the intended purpose of this manual.
ii.
Disclaimer
AMEC is devoted to publish and maintain this product manual. As we continue to improve our
AIS products to satisfy all customers’ needs, information in this document is subject to change
without notice. AMEC does not make any representations or warranties (implied or otherwise)
regarding the accuracy and completeness of this document and shall in no event be liable for
any loss of profit or any commercial damage, including but not limited to special, incidental,
consequential, or other damage.
iii.
Safety
Warning
It is important to know that AIS is designed for the purpose of anti-collision and serves as a
compliment to navigation. It is not the absolute navigational equipment and does not replace
any navigational system installed onboard.
Any AIS device cannot guarantee monitoring and receiving signals from all vessels in the
surroundings unless those vessels are equipped with AIS devices.
ELECTRICAL SHOCK HAZARD
Improper disassemble or modification could cause electrical shocks, fire, or personal injury.
Only qualified personnel could work on the interior of the equipment.
MAKE SURE THE POWER SOURCE AND THE POWER INPUT ARE MATCH
Incorrect power sources will damage the equipment and may even result in fire.
Please ensure the correct power input on the adaptor before installation.
AVOID DIRECT CONTACT WITH RAIN OR SPLASHING WATER
Electrical shock or fire could be resulted if water leaks into the equipment.
NOTE/INFORMATION
Important notices and information will be noted in this Installation and Operation Manual
iv.
Product Category
This product is categorized as “protected” in accordance with the requirements as defined in IEC 60945.
Summary of Contents for CAMINO-701
