5
PLAcEMENT
Where to place the unit on the floor
This dehumidifier can be placed on firm and even floor
leaving enough space around it for the air to flow freely,
minimum 3cm at the back and minimum 5cm at the
front of the unit. The greater the space around the unit
the better.
How to fit the unit to the wall
1. Drill 3 holes according to the dimension around 185mm x 412mm in the solid
wall as illustrated on below (fig. 1) using an 8mm drill. Place the expanding bolts
through the fixing holes in the wall brackets, press them into the wall and tighten
the nuts onto the bolts (fig. 2).
2. Insert the bracket into the slotted holder at the back of the dehumidifier, just
above the filter on the rear panel.
3. Put the two rubber feet onto the round wall mounting clips, hang up the unit on
the hanger (fig. 3).
To take down the unit, just lift it a little and pull the top forward to disengage
the top bracket from the bolt and then continue to lift it off the supports at the
bottom.
4. Check the stability of unit, make sure it is secure on the wall before using.
5. Please note that the airflow next to the wall surface may cause dirt to be
deposited in some cases. Cleaning of the wall surface may be necessary.
Min. 3cm
Min. 3cm
Min. 3cm
M
in. 3cm
M
in. 5cm
3cm
412mm
185mm
1
2
3
