20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
Networked Indexer/Driver User Manual
SD17060E-K & SD31045E-K S
PECIFICATIONS
17
Network Interface Description
The network interface is located on the top of the drive, towards the tabbed mounting surface. The network
status LED’s are also located in this area.
Ethernet Interface
The Ethernet Interface on the SD17060E-K and SD31045E-K drivers has two standard RJ-45 jacks that
accept any standard 100Base-TX cable. Both ports are also auto MDI-X capable. This means that a standard
cable can be used when connecting the Ethernet Driver to any device. Crossover cables are never needed.
Figure R1.2 Ethernet Interface Location
The “IN” network jack in the diagram above must be attached to the upstream device in the EtherCAT net-
work. (Closer to the network master.) The “OUT” jack must be attached to the next (downstream) device in
the network of the Networked Driver is not the last device in the network.
Status LED’s
Two status LED’s are located on the front panel of the Networked Driver. EtherCAT status LED’s are located
on the top of the device.
Front Panel Status LED’s
Power:
This green LED should be on when power is applied to the drive. If the LED is off, the input
voltage is below 95Vac or one or both of the internal fuses are blown. The fuses are not field replace-
able.
Status:
Steady Green ...... Driver OK
Steady Red ......... Short Circuit Fault
Over Temperature Fault
Interlock Missing
Blinking Green ... Successful write to Flash memory. Cycle power to the drive.
Blinking Red ...... Failure to write to Flash memory. Cycle power to the drive before
attempting another write.
A Networked Driver will only detect motor errors when the motor current is enabled.
IN
ERR
RUN
OUT
