20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
Installing the ANS1
4
43
Transducer Wiring (continued)
Single Resolvers
Figure 4.6 shows the connections required to attach a resolver with industry standard wire colors to a Belden
9873 or 9730 cable. If these connections are followed, you can refer to figure 4.5 on page 42 for connections
from the Belden cable to the ANS1.
Figure 4.6 Resolver to Cable Connections
Foreign Transducers
Popular transducers from other manufacturers can be used with the ANS1. The resolver must have the fol-
lowing characteristics:
Control Transmitter (Rotor as the primary)
Operating frequency between 2.2 KHz and 7 KHz
Transformation Ratio (TR) between 0.9 and 1.0
If the resolver does not have a TR between 0.9 and 1.0, a
Reference Module
from AMCI is required to make
the resolver compatible with the ANS1. The Reference Module is a single ended transformer that either
raises or lowers the reference voltage going out to the resolver so that the return signals are in the proper
range for the ANS1. The following table lists the Reference Modules available from AMCI, the TR of the
resolvers they are designed for, and the manufacturers that typically use these resolvers.
† Some manufacturers, including AMCI, allow you to specify the resolver used in the transducer. Verify all
transducer part numbers with the manufacturer before ordering an AMCI reference module.
Table 4.1 Available Reference Modules
Additional Information on AMCI Reference Modules can be downloaded from our website at:
http://www.amci.com/pdfs/accessories/RM_wiring.pdf
Regardless of the type of cable suggested by the transducer manufacturer, AMCI strongly rec-
ommends Belden 9873, 9730, or exact equivalents as cables for your transducer. With tens of
thousands of installations worldwide, AMCI is confident in the quality of these cables. If you
wish to use a different cable, contact AMCI to verify your cable type.
Part Number
Resolver TR
Manufacturer
†
RM-1
0.50
Namco/C&A Products
RM-3
1.40
Gemco, Autotech
RM-5
0.45
Electro Cam
RED
S1
BLK
S3
BLK / WHT*
A yellow wire with a white tracer is sometimes
used instead of a black wire with a white tracer.
All AMCI resolvers use a black/white wire.
R2
RED / WHT
R1
WHT
BLK
Shields of the cable must not be connected to chassis ground except at the module.
Strip the shields back to inside the cable.
GRN
BLK
BELDEN
9873 or
9730 Cable
RED
BLK
BLU
S4
YEL
S2
*
Summary of Contents for ANS1 ANYNET-I/O
