Ambit Microsystems Corporation
國碁電子
(
股
)
公司
5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.
TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\
中華民國臺灣省新竹縣新竹科學園區新安路
5
號
5
樓之
1
電話
886-3-5784975
，傳真：
886-3-5782924
14 channels for Japan
Data Rate
11Mbps with fall back rates of 5.5, 2, and 1Mbps
Spreading
11-chip
Barker
Sequence
Media Access Protocol
CSMA/CA with ACK
Transmitter Output Power
15dBm
typically
Receiver Sensitivity
Typical –83dBm for 11Mbps @ 8% PER
Typical –85dBm for 5.5Mbps @ 8% PER
Typical –86dBm for 2Mbps @ 8% PER
Typical –90dBm for 1Mbps @ 8% PER
Current Consumption
500mA at transmit mode (typically)
350mA at receive mode (typically)
40mA at normal power saving mode (typically)
30mA at max power saving mode (typically)
1-2 FCC Notice
U.S. Regulatory Wireless Notice
This device complies with Part 15 of the FCC Rules. This product emits radio
frequency energy, but the radiated output power of this device is far below the
FCC radio frequency exposure limits. Nevertheless, the device should be
used in such a manner that the potential for human contact with the antenna
during normal operation is minimized.
This device is intended only for OEM integrators under the following
conditions:
1) The antenna must be installed such that 20 cm is maintained between the
antenna and users. For laptop installations, the antenna must be installed to
ensure that the proper spacing is maintained in the event the users places the
device in their lap during use (i.e. positioning of antennas must be placed in
the upper portion of the LCD panel only to ensure 20 cm will be maintained if
the user places the device in their lap for use) and
2) The transmitter module may not be co-located with any other transmitter or
