55
Step 7 Remove the four screws holding the rear
burner plate in position plus the two screws
from the gas valve flange.
Step 8 Remove the rear plate.
Step 9 The jet carrier, gas inlet, and wiring
harness can now be detached from the gas
valve.
Step 10 The two screws retaining the gas valve
can then be removed.
Step 11 The gas valve can now be replaced.
Step 12 Refit all components in reverse order.
Step 13 (For Natural Gas burners ONLY).
Ensure step screw is in the correct position as
indicated in the diagram below.
Step 14 Set gas pressures to data badge or as
per section 1.11 and ensure reliable burner
performance.
Step 15 Test product and close access doors.
Summary of Contents for VISION VSO
Page 2: ...2...