INSTALLER INFORMATION
26
Briefing The Customer
All instructions must be handed to the user for safekeeping.
Show
the customer how to light and control the fire.
After commissioning the appliance, the customer should be
instructed on the safe use of the appliance and the need for regular
servicing. Frequency of service depends on usage, but MUST be
carried out at least once annually.
Operating The Appliance
If the Flame Supervision Device is extinguished either
intentionally or unintentionally, no attempt should be
made to re-light the gas until at least 3 minutes have
elapsed.
Mertik GV34 Manual Control
Igniting the Pilot Light
Turn the Right-hand knob
slightly anti-clockwise towards
the ignition position until
reaching stop, depress and
hold for five seconds (only
pilot gas flows).
Whilst still depressed, turn
further in an anti-clockwise
direction to activate the piezo. If the pilot does not light, repeated
immediately.
Continue to keep the knob depressed for a further 10 seconds, after
the pilot has been lit.
Upon releasing the knob, the permanent pilot will remain lit, if not
return to off position and repeat.
If under any circumstances the electric spark fails, the pilot may be lit
manually by proceeding with the ignition sequence as previously
described, and after turning the control knob through the spark
position, the knob should be held in and the pilot lit with a match or
other lighter.
Running the appliance at high output
Ignite permanent pilot as
shown in “Igniting the pilot
light”.
Turn the Right-hand control
knob (A) anti-clockwise to the
setting, which shows the
larger flame.
USER INFORMATION
7
