Version 1.3
©Copyright 2016, Ambient LLC. All Rights Reserved.
Page 7
5.3
Alarm Settings
While in normal time mode, press the
TIME
button once to set
ALARM1
. Press the
TIME
button
again to set
ALARM2
. Once ALARM1 or ALARM2 are displayed in the date field (see Figure 3, No.
10), perform the following:
Command
Mode
Settings
[
ALARM
] + 2
seconds
Enter Alarm Settings
Alarm Hour
Press [
UP
] to increase, [DOWN] to decrease.
[ALARM]
Alarm Minute
Press [
UP
] to increase, [DOWN] to decrease.
[ALARM]
Exit Alarm Settings
[ALARM] + 2 seconds means press and hold the ALARM button for two seconds.
[ALARM]
means press but do not hold the ALARM button.
Figure 5
5.3.1
Using the Alarm and Snooze Functions
1.
Set the alarm time as described in Section 5.2.
2.
Press the ALARM button once to turn on ALARM1
1.
3.
Press the ALARM button again to turn on ALARM2
2.
4.
Press the ALARM button again to turn on
1 and
2.
5.
Press the ALARM button again to turn off
1 and
2.
Note:
Press the
ALARM
button to turn off the alarm. If no button is pressed during the alarm
period, the alarm will turn off automatically in two minutes. To temporarily silence the alarm, press
the
SNOOZE/LIGHT
button on the top of the clock. The alarm bell icon will keep flashing.
Once the snooze function is turned on, the 4-step crescendo alarm will sound every five minutes. Press
the
ALARM
button to silence the alarm.
5.3.2
Setting the Pre-Alarm
The purpose of the pre-alarm is to allow extra time for preparation when the temperature is below
26 °F (-3 °C). The pre-alarm will sound 30 minutes before the alarm setting. To set the pre-alarm:
1.
Press the TIME button to display the ALARM1 or ALARM2 time.
2.
Press the ALARM button once to turn on the ALARM
.
3.
Press the ALARM button again to turn on the pre-alarm. The icon
LO
will appear next to the
alarm time.
4.
Press the ALARM button again to turn off both the alarm and pre-alarm.
5.4
Projector and Backlight
5.4.1
Using the Projector and Backlight
Note:
The projector and backlight are temporary when operating on batteries only, to save
battery life.
1. When the clock is powered by the battery. Press the
SNOOZE/LIGHT
button to turn on the
projector and backlight for 5 seconds.
