Version 2.12
©Copyright 2020, Ambient LLC. All Rights Reserved.
Page 12
1.
Remove the battery door on the back of the transmitter(s) by sliding down the battery door, as
shown in Figure 10 .
Figure 10
2.
BEFORE
inserting the batteries, locate the dip switches on the inside cover of the lid of the
transmitter.
3.
Channel Number:
The WS-2000 supports up to eight transmitters. To set each channel
number (the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Figure
11.
4.
Temperature Units of Measure:
To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Figure 11.
Switch in down position.
Switch in up position.