50D0033 Rev 1 June 2002
Page 4 of 7
Ambient Technologies
A Division Of
Monessen Hearth Systems
Setting Privacy Security Code on Transmitter and Receiver
The remote receiver and transmitter security codes are preset at the factory. A privacy code can be set into the
system to prevent accidental operation by other transmitters in the vicinity using the following procedure:
1.
Press the two push buttons on the receiver simultaneously and then press ON/HI button on the transmitter
once.
2.
The receiver LED will blink twice and the security code is now set.
3.
The system is ready to operate.
Remote Transmitter:
Installing Batteries:
The remote transmitter uses three (3) “AAA”-
size batteries. To install batteries,
1.
Press down the battery door tab and
lift up and remove the battery door.
2.
Install the batteries as indicated in the
receiver cover.
3.
Close the battery door by snapping in
place.
4.
The batteries should be replaced at
least once every 6 months or when the
battery indicator flashes.
Reset Button:
1.
The reset button can be used to reset the systems such as the clock setting. The reset button is located
behind the battery door cover.
2.
Using a paper clip, press the button and the system will reset and go into clock setting mode. Follow the
instructions on how to set the time in the next section.
Back of the Transmitter
Battery
Door
Tab
Reset Button
(Behind battery door tab)
f i r e - p a r t s . c o m
