8
Installation
Instructions
•
Do not connect the unit to the mains socket before installation. Ensure you are
not installing the unit right in front of the mains socket. This is to avoid potential
damage to the back of the unit.
•
After installing the appliance, ensure that the mains plug is easily accessible.
•
The electrical connection conditions must correspond with the specifications
on the rating plate of the dishwasher. Do not use extension cables.
• Position the unit next to a water tap and a drain.
• Level the unit if needed.
• Ensure the water inlet and drain hoses are not kinked or squashed. The unit
must not stand on the electrical supply cable.
•
Make sure your plumbing is suitable for use with the dishwasher. If in doubt
contact a qualified plumber. This unit MUST BE connected to COLD WATER
MAINS using the new water inlet hose. OLD HOSE SETS MUST NOT
BE RE-USED. The water pressure from the water mains needs to be at a
minimum of 0.04 MPa and a maximum of 1.00 MPa.
•
Connect one end of the safety water supply hose to your dishwasher, and
then connect the other end of the hose to your water mains. Please ensure
the black rubber seal is in place.
•
You may use a Y-adaptor (not included) for an additional water feed for
another appliance, for example a washing machine. This is only applicable for
cold water mains. A Y-adaptor is available from most DIY stores.
•
After connecting the hose, turn on your water mains and check for leaks.
•
Connect the dishwasher to a suitable mains socket.