4
www.ambaproducts.com
INSTALLATION
INSTRUCTIONS
CAUTION:
DO NOT TAKE OFF THE PROTECTIVE P.V.C. TAPE BEFORE INSTALLING TOWEL WARMER TO
AVOID SCRATCHING, MARKING OR GRAZING THE SURFACE.
Setscrew
Threaded
Long Tube
•
Take the threaded long tube (4) and screw it
down completely to the threaded wall-support (2)
; to adjust the distance from wall unscrew tube
Brick Wall
Plastic
Anchor
Brick wall:
•
Drill the holes in the wall ø6 mm ( 1/4 inches)
and put the plastic anchor (1) into the wall;
Drywall:
•
Leave out the plastic anchor (1) and proceed
with step 2
STEP 1
STEP 3
STEP 5
STEP 6
STEP 2
Drywall
Anchor
Screw
Drywall:
•
Fasteners should be fixed to studs or structural
members behind the drywall
•
If not possible on both sides, toggle bolts can
be used on one side.
•
Proceed laying the threaded wall-support (2)
on the hole and fasten it with the anchor bolt
screw: repeat this procedure also for the other
points marked on the wall
Fixing Screw
Bushing
BACK SIDE OF
TOWEL WARMER
•
Laythe bushing (7) on the holes of the towel warmer.
And fasten it with the fixing screw (6);
•
Repeat this procedure also for the other connecting
holes of the towel warmer.
•
Install the towel warmer in the four connections as
shown in drawing. Technical Drawings can be found
on our website www.Ambaproducts.com
•
For each leg fasten the Setscrew (5)
Threaded Wall-
Support
STEP 4
INSTALL DIGITAL HEAT CONTROLLER OR
SWITCH — SEE PAGES 6 OR 7.
REMOVE THE PROTECTIVE P.V.C. TAPE BEFORE
SWITCHING THE TOWEL WARMER ON
