Amb-OS Media AMR-100I, Operation Manual, Page: 7 / 52

Audio
The most commonly used audio connections will be the XLR
type low impedance analog audio. Plug the cables into the
port or target you want to use. A detailed description of the
ports can be found in the Audio Installation section. If you
connect one of the digital outputs, you will need the
appropriate connector. Please go to the
Digital Audio
installation section.
Power
When you plug in the power cord, the unit
will begin its
power up sequence and
initialization process . This takes about 20
seconds and the light on the front will light.
Remember, this is
not a power switch. It is
only a power indicator.
Boot Process
After the AMR-100-I receives power, it begins its startup process.
1. Reset the drive
2. Initialize the drive
Rev. 1 – Firmware version 2.03 7
©
2012
NOTE
There is no power switch, the front panel light is only an indicator of power.