15. Remove the bolt
1
with the press roller.
16. Move the press roller
3
with the setting bushing
2
to the desired position.
17. Install the press roller with bolts.
18. Tighten the lock nut.
19. Put the ratchet spanner back in the threaded
cartridge.
20. Check the adjustment of the press rollers on the
field after driving a short distance.
1
-
+
2
3
CMS-I-00001928
6.4.16.9 Changing the furrow former
NOTE
The furrow former must be adapted to the
respective operating conditions.
NOTE
The depth control wheel and cutting disc are
only partially shown for a better view. The depth
control wheel and the cutting disc do not need to
be removed to change the furrow former.
1. Raise the implement.
2. Secure the tractor and implement.
3. Loosen the bolt
1
.
4. Remove the bolt and the bolt lock.
5. Pull out the furrow former
2
downwards.
6.
To select the furrow former,
see "Determining the setting parameters".
7. Install the desired furrow former.
8. Install the bolt and bolt lock and tighten.
9.
To install the suitable catch roller for the furrow
former,
see "Changing the catch roller".
2
1
25 Nm
CMS-I-00002045
CMS-T-00003900-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6967-EN-II | C.1 | 27.09.2021
124
