1.
Raise the implement.
2.
Release the linch pin
2
.
3.
Hold the wheel mark eradicator by the recessed
grip
1
.
4.
Remove the locking pin
3
.
The maximum working depth is 150 mm.
5.
Move the wheel mark eradicator to the desired
position.
6.
Secure the wheel mark eradicator with the locking
pin.
7.
Secure the locking pin with the linch pin.
1
2
3
CMS-I-00000942
6.3.4.2 Adjusting the track width of the wheel mark eradicator
1.
Loosen the nuts for the clamp connection
2
.
2.
Move the wheel mark eradicator bracket
1
to
the desired position.
3.
Tighten the nuts.
4.
After 5 hours of operation, check the bolt
connection for tight fit.
1
2
CMS-I-00000943
6.3.4.3 Replacing the wheel mark eradicator coulter
Different wheel mark eradicator coulters can be
installed on the wheel mark eradicator . The choice
of the wheel mark eradicator coulter depends on the
operating conditions.
CMS-I-00001967
CMS-T-00001553-B.1
CMS-T-00002425-C.1
6 | Preparing the machine
Preparing the implement for operation
MG6214-EN-II | E.1 | 17.05.2021
53
