Amazone AmaTron 4, Operating Instructions Manual, Page: 42 / 111

2.2 Configuring non-ISOBUS implements
1. In the main menu, select .
2. Select the desired implement under "Implements" .
For correct representation in the map view, the
implement modelling must be specified.
The specifications depend on the following factors:
whether the connected implement is mounted or
towed.
whether the GPS receiver is installed on the tractor
or on the implement.
whether the implement is self-propelled.
3.
If the connected implement is mounted or the
implement is self-propelled,
select "Mounted" under "Implement modelling"
or
If the connected implement is towed,
select "Towed" under "Implement modelling" .
4. Enter the implement type and manufacturer.
The implement geometry includes the following
values:
X1: distance between the attachment point and the
application point
X2 on towed implements: distance between the
attachment point and the rear axle
If the GPS receiver is installed on the implement, the
position of the GPS receiver must be entered through
the implement geometry.
A: Transverse offset of the GPS receiver relative to
the attachment point
B: Longitudinal offset of the GPS receiver relative to
the attachment point
5. Enter the values for X1 and X2 under "Implement
geometry" .
6.
If the GPS receiver is installed on the implement,
enter the values for A and B under "Implement
geometry" .
CMS-T-00000322-D.1
K | Configuring implements | Configuring non-ISOBUS implements
MG6010-EN-GB | G.1 | 13.12.2018 40