10
ENGLISH
TROUBLESHOOTING
The shredder runs in “Rev (Reverse)” mode but not in “Auto (On)” mode.
While in “Auto” mode, the motor will not start running until paper is inserted into the feed slot. Set the
unit to “Auto” and insert paper to shred. The sensor that activates the shredder in Auto mode is located
directly in the center of the slot. If the paper you are inserting is narrow, it may not be activating the
optical sensor. It is also possible that the feed slot has become blocked with paper. Insert an index card
or any rigid sheet of cardstock (old greeting card or folded file folder), directly in the center of the feed
slot, while applying force to help push the jammed paper through. This will usually clear any paper
blockage.
How to clear a paper jam in the shredder.
1)
Switch the shredder over into Reverse (REV) mode. While in Reverse, the shredder will back up and
loosen the jammed paper. If required, you may need to tug and remove several sheets to effectively
clear the machine. When jammed paper is loosened or removed, switch back to the Auto-On mode
to continue shredding. Repeat steps if needed.
2)
With stubborn situations where the reverse function does not help, you may loosen the jammed
paper with shredder oil (cooking oil is acceptable, nothing aerosol). Start by drizzling oil into the
feed slot where the paper is jammed. Let it soak for about 30 minutes to completely saturate. Return
the shredder back to
Auto-On mode
.
If required, an index card or a rigid sheet of
cardstock (old greeting card or folded file folder) can be fed into the shredder to
help push the jammed paper through.
The shredder is constantly running while in “Auto (On)” mode.
1)
It is possible that the activation sensor, which starts the shredder, has become blocked with paper.
Insert an index card or any rigid sheet of cardstock (old greeting card or folded file folder), directly
in the center of the feed slot, while applying force to help push the jammed paper through. This will
usually clear any paper blocking the activation sensor and feed entry.
2)
The activation sensor is being triggered by dust, debris, or oil. A cotton swab may be
used to clean the sensor. DO NOT USE CANNED AIR. The activation sensor of the shredder is
located around the center of the feed entry.
Power switch in auto position
Use thick paper stock or greeting card
to push the jam through
