Figure 24
Now slide the end of the long strap through the
hole in the roll bar. There are two holes in the roll bar.
Slide the strap throught the roll bar on the same side
as the long strap.
Take the small plastic pin and slide it into the loop
at the end of the long strap. Now pull on the strap
from the front, until it locks in place against the roll
bar.
Figure 25
Your assembled seat belt will look like Figure 25.
Figure 26
There are 3 pieces to the AMAV Power Rider™
safety flag. (2 rods and the flag pennant). Take the
larger rod and slide it into the roll bar as shown in
Figure 26.
Then take the second rod and slide it
into the top of the first rod. The flag
pennant then slides on top of the
assembled rods.
9
Figure 20
Figure 21
Figure 22
Figure 23
Figure 26
Figure 24
Figure 25
Roll Bar, Seat Belt
and Flag
Figure 20
To attach the roll bar, just line up the four ends with the holes
in the car body and snap it into place.
Figures 21, 22 and 23
Your seat comes with the seatbelt installed, but without the
clips in place. (Figure 21). There are two clips (male and female)
as shown in Figures 22 and 23. Attach the male clip to the short
strap by sliding the strap in and through as shown in Figure 22.
Once the strap is through, pull the clip so that the strap is sitting
tightly in the clip.
To attach the female clip to the long strap, just slide the strap
through, leaving the clip at about the middle of the strap.
Male clip goes here
Male
clip
Female
clip
Female clip goes here
Back
Front
