Amart Furniture Spacesaver 49154, Assembly Instructions Manual

Page: 3 / 22

If it will not turn the full amount, turn the Cam Pin out
Open section of back
fits over the head of
the Cam Pin
Cam Pin
Collar
Cam Lock
Cam Pin
BoardB
BoardA
To assemble this product hardware called Cam Lock Fasteners
Cam Locks are fasteners used to join two boards together,
The cam pin is kept vertical and is not put in on an angle.
Cam pin is to be inserted up to collar
Too far and it wont catch the Cam Lock (Do Not Overtighten)
Not enough and the resulting product will not be stable.
are used. The below is information on how these work.
usually the edge of one board (A) to the flat side of another
board (B).
The Cam Pin is inserted into the flat side of a board, it is important that:
Now fit the hole in the edge of the joining board over the
Cam Pin.
The Head of the Cam Pin will be visible
in the large hole on the side of the
joining board.
Head of the Cam Pin
Notice the Cam Lock has a “C” Shaped Back.
An arrow or +/- signs on the front indicate the open
open section on the back of the Cam Pin.
Insert the Cam Lock into the large hole so the opening
of the “C” fits over the head of the Cam Pin. You must
ensure that the Cam Lock is pushed to the bottom of
the hole to catch the top of the Cam Pin.
Use a Flat screwdriver to turn the Cam Lock
clockwise one half turn so it locks onto the head of
(Counter-clockwise) one full turn, and try the Cam
Lock again.
the Cam Pin. Turn only until it is snug. Over
tightening could cause the Cam to bend or break.
TO USE CAM LOCK FASTENERS