NOTES
- 29 CH mode:
1. If CH 3 = 00, CH 2 and CH 5 to CH 29 invalid.
2. If CH 3 = 00 and CH 2 = 00, CH 5 to CH 29 invalid.
3. If CH 3 = 00 and CH 2 = 00, CH 5 to CH 29 valid.
- 4 CH & 9 CH mode:
1. If CH 3 = 00, CH 2 invalid
2. If CH 3 = 00, CH 2 valid
Channel 2
CH 2: STATIC Macros
This channel incorporates 256 static patterns (See closed table)
Channel 3 and Channel 4:
CH 3: DYNAMIC Macros
In channel 3 there are stored some BUILT-IN effects, but in this case, they are not static, each value of the channel c
orresponds to a CHASE with various steps. Maximum number of steps of one chase is 35. The chase will loop, it
means when the chase is finished will start again.
CH 3 DYNAMIC PROGRAM: 1. 001-043: 43 built-in programs.
2. 044-127: No program
3. 128-230: 103 built-in programs
4. 231-255: No program
Example:
CHANNEL 3 VALUE 000: In this position is stores the following sequence:
"PARMATRIX DESIGNS BY EQUIPSON"
This is a Chase of 26 steps: First step corresponds to "P", 2nd to "A", and so on till the last step. After the last step,
the chase restars again.
CH 4: Speed
With channel 4 we control the speed of the channel 3, and ther direction of the chase, if it is running FORWARD OR
REWIND (BACKWARD).
Values:
- Value 000 - 050: STOP
- Value 051 - 150: 0.1 seconds to 10 seconds FORWARD SPEED
- Value 151 - 250: 0.1 seconds to 10 seconds REWIND SPEED
- Value 251 - 255: STOP
/
/
/
Example: If we have selected in channel 3 the value 000, that corresponds to the chase mentioned above:
"PARMATRIX DESIGNS BY EQUIPSON"
Then in channel 4 we have selected:
- Value 000 - 050: The fixture will show "P"
- Value 051: The fixture will start to show the chase at the minimum speed.
- Value 052: increase of speed
- .........
- Value 150: Maximum speed
- Value 151: The fixture will start to show the chase in rewind mode at the minimum speed.
- Value 152: increse of speed
- .........
- Value 250: Maximum speed in rewind mode
- Value 251 - 255: STOP
PARMATRIX 25 User Manual/Manual de uso Pag. 4
EN