21
OPERATION
The fireplace can be operat ed eit her by t he sw it ches located on t he left bot t om of t he fireplace unit
or by supplied remot e cont rol.
Plug t he fireplace int o a 15 Amp wall socket .
M ANUAL OPERATION
1.
The main power ON/ OFF sw it ch in posit ion O, t he fireplace is OFF.
2.
When main power ON/ OFF sw it ch is at posit ion I, t he fireplace is ready t o use.
3.
Press t he
Heat
butt on repeatedly to set t he heater t o desired heat sett ing. The heater indicat or
LED w ill glow w hich shows t he current heat er sett ings.
a)
RED 1500W HEAT OUTPUT
b)
BLUE 750W HEAT OUTPUT
c)
PURPLE AUTO M ODE
AUTO M ODE
Under t his mode t he heat er w ill aut omat ically t urn ON at high heat sett ing 1500W heat out put w hen
t he room t emperat ure drops below 22
℃
(72
℉
). When t he room t emperat ure is bet ween
22-25
℃
(72-77
℉
) t he heat er out put w ill sw itch to low heat set t ing 750W. When t he room
t emperat ure goes above 25
℃
(77
℉
) t he heat er w ill be t urned off and t he cycle w ill cont inue. The
LED indicat or w ill be PURPLE in colour under t his mode.
4.
Flame effect : Press t he butt on marked
Flame
t o adjust t he flame bright ness. The flame
bright ness w ill cycle t hrough
–
Low-M edium-High -OFF.
NOTE:
If operated at t he Low heat sett ing, t he fireplace w ill not provide as much heat out put as in
t he High heat sett ing, however t he low sett ing w ill not require as much elect rical power t o operate.
To avoid overloading a circuit , do not plug t he fireplace into a circuit t hat already has ot her
appliances working. When t he fireplace is not in use sw it ch off and unplug.
SAFETY CUT-OFF
l
This appliance is fitted w it h a safet y cut-off w hich w ill operat e if t he fireplace overheat s (eg. Due
t o blocked air vent s). For safet y reasons, t he fireplace w ill NOT aut omat ically reset .
l
To reset t he appliance, disconnect t he appliance from t he main supply for at least 10 minut es.
Reconnect t he supply t o t he main and sw it ch on t he appliance.
Summary of Contents for BI-40-SLIM
Page 16: ...4 Bend up the framing plates 5 Put the unit into the opening 16 ...
Page 25: ...25 EXPLODED VIEW ...
Page 28: ...28 ...
