4
www.amano.com/time
800-253-9836
PIX-75
Atomic Clock Diagnostic ON (Code
11
)
By entering this code, the clock turns on the diagnostic mode for the
atomic clock sync data and displays the raw data received by the atomic
clock receiver chip on the bottom line of the LCD when it is trying to sync
with atomic clock. The clock displays the message “DEBUG ON”
Atomic Clock Diagnostic OFF (Code
12
)
By entering this code, the clock turns off the diagnostic mode for the
atomic clock sync data. The clock displays the message “DEBUG OFF” and
goes back to the previous menu.
Reset Settings to Factory Defaults (Code
32
)
By entering this code, the clock resets all user settings (except the time,
time zone, DLS start/ end date, and ink count) to the factory defaults
settings. The clock displays the message “Wait” and “RESET” on the LCD
screen and restarts.
Show Advanced Diagnostic Settings (Code
65
)
By entering this code, the clock will show the advanced diagnostic mode
settings. If the code is accepted successfully, the clock will display
“ADVANCED” and go back to the diagnostic menu. After entering the
diagnostic menu, it will show following advanced settings.
Crystal Adjustment
Using this setting, the user can set the crystal aging offset to run the
clock crystal faster or slower. This adjustment will appear on the display
as
P6
05
advanced
then show
P6
06
crystal adjust.
This will
allow the crystal aging offset to be adjusted to run the clock crystal faster
or slower.
Show Total Prints (Code
98
)
By entering this code, the clock will display the total number of prints the
PIX-75 clock has printed since it was manufactured. This count can’t be
reset.
Invalid Codes
By entering any other code than mentioned above, the clock will display a
message “ERROR” and go back to the previous menu without performing
any action.
7.
Press the
PROGRAM
or
ENTER
button once to exit and go back to the
previous menu.
8.
Replace the cover to return the clock back to normal operation.
