MTX-30P Push Installation & Operation Guide
Page 10
Startup
MTX-30P Push Startup AMANO Screen (Power On)
Once the terminal is wall mounted and the communication connections have been made,
connect the terminal to AC power and proceed on to setup and enroll users.
To start-up, perform the following:
Ensure the AC Power Adapter is connected to the MTX-
30P Push terminal and plugged into an outlet. The MTX-30P Push terminal will display the
splash screen, perform a diagnostic check, and then display the Welcome screen.
Note: The time and date can be set with the terminal keypad, or downloaded to the terminal from the
host PC or cloud utilizing Time Guardian software. The information such as date, time, daylight saving
time (DST), proximity card templates, and hours worked sent from Time Guardian software will have
precedence over existing similar information. That is to say Time Guardian software will act as the
master/source.
Upon power up, the Green LED indicator will blink once every second to signify the terminal
is operating properly.
All normal time and attendance functions (validation for punch in/out) must be performed from
the Welcome screen.
Press the power On/Off
button to shut down the MTX-30P Push proximity card terminal
and display "halting system….Shutdown 2 secs, 1sec". The MTX-30P Push terminal will
retain all templates and transactions while the power is off.