INSTRUCTIONS FOR AMANA QUARTZ FLOOR CLOCK
Dear Amana Customer,
Thank you for investing in an original Amana clock. These instructions are intended to provide information
needed to set up and operate the clock. Please read these instructions carefully before you begin. Please
contact us at the Amana Furniture Shop if you have any questions.
NOTE:
Locate the clock pendulum before disposing of any material.
OPERATING INSTURUCTIONS (see attached diagram)
Detach the clock face from the cabinet by grasping the side of the dial board and carefully lifting up.
Unlock pendulum holder from its shipping position on the back of the pendulum driver by gently sliding to the
right until it hangs freely.
Before inserting the batteries, make sure to set the time to 5:45 a.m. by turning the hand-setting knob on the
movement.
Insert a battery into the pendulum driver (1 D size) and into the clock movement (2 C size). Insert the batteries
according to (+) and (-) marking in the battery compartment.
Place the clock into its location and using the levelers on the bottom of each foot, level the clock cabinet.
Carefully hang the pendulum onto the pendulum hanger.
To set the time and melody, please turn the hand CLOCKWISE. If the present time is P.M., make sure the hour
hand passes through 12 o’clock until the desired time is shown. During time setting you will hear sounds, but
continue until the desired time is shown. Once the desired time is set, the melody will sound correctly.
The 4x4 mode will not work correctly during the first hour after time is set. After that, however, it works
perfectly. This is a normal condition for this movement.
Place clock dial back onto clock by aligning the metal bracket on the dial board and the bracket on the clock
body.
MELODY FUNCTION
MONITOR:
(a) To demonstrate the hourly sound, select the melody by (e) button and press the “MONITOR”
button.
VOLUME:
(b) Rotary volume
SET:
(c) Advances the strike count one hour for every push of the button.
RESET:
(d) Resets the clock as if the batteries had been removed and re-inserted. If you press this button, you
must again follow the directions above as if placing new batteries into the clock.
SELECT:
(e) Melody select.
