5
VENT CONTROL AND AIR DIRECTION (See Figure E)
The vent control is located behind the front grille on the right side
of the air discharge area. When set at
CLOSE
only the air inside
the room will be circulated and conditioned. When set at
OPEN
,
some inside air is exhausted outside.
Locating
Hole
Locating
Hole
Screw Hole
Screw Hole
OPEN position
(Mesh end toward back)
CLOSE position
(Mesh end toward front)
Figure E
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove the vent card, turn it over and replace it by locating
rear hole in card over locating pin inside air discharge and
reattaching screw at front.
Figure 4
Screw
AIR DIRECTION:
Horizontal louvers on the front grille let you control the air direction
up and down.
Remove the front grille to adjust the vertical louvers side-to-side
to direct the air left or right.
Figure 5
IMPORTANT NOTES:
1. The unit is equipped with a rubber-grommet-mounted
compressor. These grommets are factory set and require
no adjustment.
2. Obstruction to air flow must be checked and removed.
Check the indoor and outdoor grilles for obstructions. The
unit must be located where curtains, furniture, trees, or
other objects do not block air flow to and from the unit. If air
is obstructed and/or deflected back into the unit, the air
conditioner’s compressor may cycle on and off rapidly.
This could cause damage to the compressor.