Amana AER5725QAW, Use And Care Manual, Page: 8 / 20

7
CAUTION
Oven Door
Do not place excessive weight on or stand on an open
oven door. This could cause the range to tip over, break
the door, or injure the user.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Important: The oven door on a new range may feel “spongy”
when it is closed. This is normal and will decrease with use.
Leveling Legs
ANTI-TIP BRACKET
LEVELING LEG
LEVELING LEG
CAUTION
Be sure the anti-tip bracket secures one of the
rear leveling legs to the floor. This bracket
prevents the range from accidentally tipping.
The range should be leveled when installed. If
the range is not level, turn the leveling
legs, located at each corner of the
range, until range is level.
Oven Light
CAUTION
• Disconnect power to range before replacing light bulb.
• Allow oven to cool before replacing light bulb.
• Make sure bulb cover and bulb are cool before touching.
Maintenance
Storage Drawer
The storage drawer can be removed to allow you to clean
under the range.
To remove:
1. Empty drawer and pull out to the first stop position.
2. Lift up the front of the drawer.
3. Pull out to the second stop position.
4. Grasp sides and lift drawer up and out.
CAUTION
Do not store plastic, paper products, food or flammable
materials in this drawer. The drawer may become too warm
for these items when the oven is in use.
To replace oven light bulb:
1. When oven is cool, hold bulb
cover in place, then slide wire
retainer off cover.
Important: Bulb cover will
fall if not held in place
while removing wire
retainer.
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appliance bulb.
4. Replace bulb cover and secure with wire retainer.
5. Reconnect power to range. Reset clock.
BULB COVER
WIRE
RETAINER
To replace:
1. Fit the ends of the drawer glides into the rails in the range.
2. Lift up the front of the drawer and gently push in to the
first stop position.
3. Lift drawer up again and push until drawer is closed.
ANTI-TIP
BRACKET