21
Form bare ground wire into a U-shaped hook. Wrap ground wire
hook clockwise around the ground connector screw on the raised
floor inside the box and under the washer. Securely tighten
ground connector.
Select UL Listed/CSA Approved twist-on wire connectors of the
proper size. See the “Tools and Parts” section at the front of the
guide for part details. Connect wires, black to black and white to
white, using the twist-on wire connectors.
NOTE:
Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Tighten strain relief screws to secure cable. Make sure screw
heads are facing up when tightening conduit nut.
Place wires inside terminal box. Replace the cover by inserting the
hooks of the terminal cover into the slots in the floor of the
terminal box and sliding the cover tight against the back wall
where wires come in. Make sure wires are tucked inside the box
and not pinched by the cover. Then, put the terminal box back on
the crossbar with the tab in place. Use a
¹⁄₄
" nut driver and the
previously removed screw to secure the terminal box to the
crossbar.
Once the terminal box has been remounted on the dishwasher,
there should be some excess length or slack in the green, black,
and white wires coming from the dishwasher to the terminal box.
Wrap these wires over the nearby components, or clip them back
into the nearby clips that they were routed through prior to your
removing the box, to help keep them off the floor.
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Summary of Contents for ADB1700ADB
Page 75: ...75...