9
Programming Pads
Oven is shipped from the factory for single pad programming. To change
the oven default to allow double pad programming, see
User Option
s.
To change the amount of time or the power level for a preset pad:
1. Open oven door.
•
READY
displays.
• If door is closed or RESET pad is pressed before programming is
complete, changes are discarded and microwave exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
• This begins programming mode.
• Microwave will beep and
P:0
displays. Oven is in
programming mode.
3. Press pad to be reprogrammed.
• Press two pads if reprogramming a double pad program.
•
COOK LEVEL
and cooking time display.
• A number displays with
COOK LEVEL
if it is less than full power.
4. Enter cooking time by using the number pads.
5. Press POWER LEVEL pad to change power level if desired.
• Use the number pads to change power level to a lower
power setting.
6. Press START pad to set new programming to the pad.
• If START is not pressed, changes will not be saved.
•
P:0
displays
7. Press STOP/RESET pad or close oven door to exit
programming mode.
Programming the Oven Control
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a
memory pad. To use stage cooking:
1. Follow steps 1 through 5 above.
6. Press TIME ENTRY pad.
• Display briefly shows the pad number that is being programmed
and the stage number to the upper right.
• Display changes to cook time and power level for the next
stage.
7. Enter cook time and power level as in steps 4 and 5.
• To enter another cooking stage for that pad, press TIME ENTRY
pad again.
• Up to four different stages can be programmed.
8. Press START pad to set new programming changes to the pad.
X2 Programming
This feature allows a preset
percentage of original cook time,
called a cooking factor, to be added
to a cook sequence.
To change the cooking factor:
1. Open oven door.
2. Press and hold pad 1 for
approximately 5 seconds.
3. Press pad to be reprogrammed.
4. Press the X2 pad.
5. Press a numbered pad to
change the cooking factor.
• Pad 5 would change the
cooking factor to 50%.
• Pad 3 would change the
cooking factor to 30%.
6. Press START pad to save changes.
X
