1.2
Acessing setup for scaling, relays and display brightess
Use the method below to access the display scaling, relay high and low setpoints and brightness
level setup. Note that DIP switch 4 must be in the ON position to access the scaling functions and
in the OFF position to access the alarm relay and brightness functions.
If DIP switch 4 is set to ON then Channel 2 bargraph should blank refer to chapter
4
for further
details.
If DIP switch 4 is set to OFF then one bargraph or both bargraphs should flash indicating a relay
number see chapter
6
for further details.
4 of
18
PM4IV2MAN-1.1-0
