AM.PM INSPIRE F5000000, Manual, Page: 3 / 15

4 5
4. Fasten the mixer on the sanitary ware,
using the supplied fasteners.
SURFACE MOUNT BATH MIXER
5. Connect the mixer to the water supply
system, using the connecting ittings (upset
couplings). Turn on the water supply. In the
closed position of the mixer, check sealing of
all the connections. If necessary, make extra
tightening and sealing of the connections (be
sure to close the shut-off valves on water
supply piping).
6. Start the cold and hot water running for a
short period of time (to wash off the pipes),
then close the water supply and install
(tighten) the aerator.
F5010000
2. Remove (unscrew) the aerator (to avoid
clogging the aerator at the irst start-up of
water).
3. Fasten the trim to the eccentric reducers,
using tool with soft parts (to avoid damage to
the decorative coating of mixer nuts), mount
the mixer housing.
Operating pressure range in the water
supply is 1.5 – 6.0 atm (120-600kPa).
Pressure difference for hot and cold water
can vary + / - 10%. The recommended
pressure is 2.5 atm. If pressure parameters
in the water supply differ from the speciied
value, input pressure boosting systems or
input pressure reducing valve is required.
To avoid ingress of foreign solids (abrasive
particles) in the mixer, it is recommended to
apply 100-300 micron ilters.
F5020000
1. Close off hot and cold water supply.
Screw in the lat-end reducers. Screw in the
eccentric adapters in water supply piping
outlets with pre-sealing of the threaded part
with insulating material. Adjust the position
of eccentric reducers so that they match
and meet the connecting position of the
mixer, and the mixer is horizontal (distance
between the eccentrics – 150mm OC).