8. Assembly Steps – Gimbal Controller Board
Step 1.
Usage of different ports on the Gimbal Controller.
(Best working power is 11.1V 3S Lipo.)
Step 2.
Insert the Tilt and Roll Controlling Connector into the
Til and Roll Control Port on the Gimbal Controller.
Step 3.
Tilt Axis is controlled with 2-wire
connector(Black=Ground, Red=Signal), and the Roll
Axis is controlled with 1-wire connector. Connect
these connectors into two free channels of your
receiver. Adjust the limit of the channels as to limit the
Tilt into +-60 degree, and Roll into +-80 degree or
bellow for stable performance.
Step 4.
Connect IMU Unit cable to the IMU port of Gimbal
Controller. And connect Tilt and Roll Motor cables to
the motor ports of Gimbal Controller.
(Follow the
exact direction for for all connections.)
Page 14 of 16
