220
BreezeMAX Wi² and BreezeACCESS Wi² System Manual
Appendix B - Resetting to Factory Defaults
B.1
Introduction
To force an AP into its factory default state, follow the procedures in this section.
B.1.1
Using the Reset Switch
Not applicable to the ruggedized Wi² AP.
Using a tool such as a paper clip, press and hold the reset switch for a few seconds until the front
status lights flash three times.
B.1.2
Using the Management Tool
Launch the management tool (default https://192.168.1.1).
To reset the AP to factory defaults,
keeping it in autonomous mode
, follow this procedure:
1
Select
Maintenance > Config file management
.
2
Under
Reset configuration
, click
Reset
.
CAUTION
Resetting an AP to factory defaults deletes all configuration settings, resets the administrator
username and password to admin, enables the DHCP client on the LAN port(s), sets the IP address
of the port(s) to 192.168.1.1.
NOTE
Some of the techniques described in this appendix cause the AP to be forced back into its default
controlled mode. If desired, after performing the factory reset, switch the AP back into autonomous
mode by following all the directions in
“To perform these initial login tasks” on page 62
NOTE
Licenses are retained after a factory reset. See
“Factory Reset Considerations” on page 213
NOTE
This technique forces the AP into its factory default state including switching the AP back into
controlled mode.
Summary of Contents for BreezeACCESS Wi2
