G03711103
8-22-06
Page 7 of 9
10
Snap the fillers [
P
] into the curb assembly [
A
] and
header assembly [
D
] between the door jambs with the
raised lip to the exterior and the pivot holes toward the
pivot jamb [
M
]. Center the curb filler in the curb between
the pivot and strike jamb [
N
] (use masking tape to hold in
position).
NOTE: The snap-in fillers should be exactly 3/8" longer
than the door panel width.
11
Pull the bottom end of the pivot jamb [
M
] tight to
the curb filler [
P
] and plumb the jamb. Drill two 1/8"
holes thru the pivot jamb and into the 135° post [
J
] in line
with the screws in the head and curb and approximately
1/4" vertically from the ends of the jamb. Drill a third
hole centered between the first two. Attach the pivot
jamb permanently with three #8 x 1/4" truss head screws
[
C
].
Slide the header filler [
P
] tight against the pivot jamb.
Push the strike jamb [
N
] tight against the fillers top and
bottom. With the pivot jamb plumb and both fillers tight
between the two door jambs, the strike jamb also will be
plumb and parallel to the pivot jamb. Attach the strike
jamb to the other 135° post [
J
] in the same manner as the
pivot jamb.
12
Insert the two #10-24 x 7/16" square head set
screws [
W
] into the threaded holes in the pivot blocks in
the top and bottom rails of the glazed door panel [
L
].
Position the pivot pins 1 1/2" from the pivot side of the door
(the side opposite the magnetic strip). Tighten the set
screws just enough to prevent the pivot blocks from
moving (finger tight plus a quarter turn). A 3/16" wrench
(not supplied by A
LUMAX
) will fit the set screw heads
Press the white nylon spacer [
X
] over the bottom pivot pin
on the door panel.