Chapter 2. Hardware Setup
11
Installing the KE8220 Virtual VNC Console
You will need the following items to install the KE8220 Virtual VNC Console:
1 display device (monitor or projector)
1 keyboard
1 mouse
1 Cat 5 cable
an Ethernet connection
an AC power source rated for the KE8220
To install the KE8220 Virtual VNC Console:
1. Connect the display device, USB keyboard, and USB mouse cables to the
console ports. The ports are marked with a monitor, keyboard, or mouse
icon. Or, if you wish to use a PS/2 keyboard and mouse, see
Note:
If you are installing a wireless keyboard and mouse that share the
same wireless receiver, and the receiver has a USB connector,
connect it to the keyboard port on the back of the KE8220. The port
is marked with a keyboard icon.
2. Connect one end of a Cat 5 cable to your Ethernet network and the other
end to the LAN port on the back of the KE8220. Or, if you wish to use the
KE8220 on a wireless network, see
3. Plug the power adapter into an appropriate AC power source, and then
plug the power adapter cable into the power jack on the back of the
KE8220.