Vertiline3D/VertiLine6D
- 3 -
10. The power LEDs on the faceplate for Outputs 1-8 will illuminate when AC power is present
(Fig. 1a, pg. 4).
Note:
If any of the power LEDs are not illuminated the cause may be due to the following:
a.
AC mains fail.
b.
Illuminated master power disconnect circuit breaker is OFF or tripped.
c.
One (1) or more power output PTCs are tripped due to a short circuit or overload condition.
To reset the PTC:
1.
Set illuminated master power disconnect circuit breaker to the (OFF) position
(Fig. 1d, pg. 4)
.
2.
Eliminate the trouble condition (short circuit or overload).
3.
Allow 1 minute for PTC to cool off (reset).
4.
Set illuminated master power disconnect circuit breaker to the (ON) position
(Fig. 1d, pg. 4)
.
5.
All power LEDs will illuminate indicating power has been restored to all outputs
(Fig. 1a, pg. 4)
.
