- 2 -
T2MK7F4D
Overview:
Altronix T2MK7F4D Trove Mercury kit is pre-assembled and consists of Trove2M2 enclosure with factory installed Altronix power
supply/charger and sub-assemblies. T2MK7F4D kit also accommodates various combinations of Mercury boards for up to four (4) doors
in a single enclosure.
Configuration Chart:
Altronix
Model Number
120VAC
60Hz
Input
Current (A)
Power
Supply
Board
Input Fuse
Rating
Power
Supply
Board
Battery
Fuse Rating
Nominal DC
Output Voltage
Maximum Supply
Current for Main
and Aux. Outputs
on Power Supply
Board
ACM4CB
Board
Input
Fuse
Rating
ACM4CB
Board
Output
PTC
Rating
PD8ULCB
Board
Output PTC
Rating
[DC]
[Aux]
Output
Range
(VDC)
Output
Range
(VDC)
T2MK7F4D
4.5
6.3A/
250V
15A/
32V
20.19-
26.4
20.19-
26.4
24VDC @ 9.2A
10A/32V
2A
2A
Installation Instructions:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities having
jurisdiction. Product is intended for indoor use only.
1. Remove backplane from enclosure. Do not discard hardware.
2. Mark and predrill holes in the wall to line up with the top two/three keyholes in the enclosure. Install two/three upper fasteners and
screws in the wall with the screw heads protruding. Place the enclosure’s upper keyholes over the two/three upper screws;
level and secure. Mark the position of the lower three holes. Remove the enclosure. Drill the lower holes and install the three
fasteners. Place the enclosure’s upper keyholes over the two/three upper screws. Install the three lower screws and make sure to
tighten all screws.
3. Mount included UL Listed tamper switch (Altronix Model TS112 or equivalent) in
desired location, opposite hinge. Slide the tamper switch bracket onto the edge of the
enclosure approximately 2” from the right side (Fig. 1, pg. 2).
Connect tamper switch wiring to the Access Control Panel input or the appropriate
UL Listed reporting device. To activate alarm signal open the door of the enclosure.
4. Mount Mercury modules to backplane(s), refer to page 3.
5. Refer to the eFlow Power Supply/Charger Installation Guide for eFlow104NB
and corresponding Sub-Assembly Installation Guides for ACM4CB and PD8ULCB for
further installation instructions.
Hardware:
Fig. 1
Tamper Switch
(provided)
To Access Control Panel or
UL Listed Reporting Device
Edge of
Enclosure
Enclosure
Snap On Standoff
| 5/16” Pan Head Screw | Lock Nut
