- 2 -
T2MKD Kits
Overview:
Altronix Trove Mercury kits are pre-assembled and consist of Trove2M2 enclosure with factory installed Altronix power supply/
charger(s) and sub-assemblies. These kits also accommodate various combinations of Mercury boards for up to sixteen (16) doors in
a single enclosure.
Configuration Chart:
Altronix
Model Number
Nominal DC Output
Voltage
Maximum
Supply
Current for
Main and Aux.
Outputs on Power
Supply board
and ACM4CB/
ACM8CB
Access Power
Controller’s
outputs
Fail-Safe/Fail-Secure Auto- Resettable Outputs
120VAC 60Hz Input Current (A)
Current Per ACM4CB/ACM8CB Output
(A)
Power Supply Board Input Fuse Rating
Power Supply Board Battery Fuse Rating
ACM4CB/ACM8CB Board Input Fuse Rating
ACM4CB/ACM8CB Board Output PTC Rating
PDS8CB Board Input Fuse Rating
PDS8CB Board Output PTC Rating
PD8ULCB Board Output PTC Rating
Power
Supply 1
Power
Supply 2
[DC] [Aux] [DC] [Aux]
Output Range (VDC)
Output Range (VDC)
Output Range (VDC)
Output Range (VDC)
T2MK3F4D
20.19-
26.4
20.19-
26.4
----
----
24VDC @ 5.8A
4
3.5
2.0
5A/
250V
10A/
32V
10A/
250V
2A
10A/
250V
2A
----
T2MK3F4DQ
20.19-
26.4
20.19-
26.4
----
----
24VDC @ 5.8A
4
3.5
2.0
5A/
250V
10A/
32V
10A/
250V
2A
10A/
250V
2A
----
T2MK3F8D
20.19-
26.4
20.19-
26.4
----
----
24VDC @ 5.8A
8
3.5
2.0
5A/
250V
10A/
32V
10A/
250V
2A
10A/
250V
2A
----
T2MK3F8DQ
20.19-
26.4
20.19-
26.4
----
----
24VDC @ 5.8A
8
3.5
2.0
5A/
250V
10A/
32V
10A/
250V
2A
10A/
250V
2A
----
T2MK7F8D
20.17-
26.4
20.28-
26.4
----
----
24VDC @ 9.2A
8
4.5
2.0
6.3A/
250V
15A/
32V
10A/
250V
2A
10A/
250V
2A
----
T2MK7F8DQ
20.17-
26.4
20.28-
26.4
----
----
24VDC @ 9.2A
8
4.5
2.0
6.3A/
250V
15A/
32V
10A/
250V
2A
10A/
250V
2A
----
T2MK75F16D
20.17-
26.4
20.28-
26.4
9.7-
13.2
10.03-
13.2
12VDC @ 9.3A
24VDC @ 9.2A
16
8
2.0
6.3A/250V
5A/250V
15A/
32V
10A/
250V
2A
----
----
2A
T2MK75F16DQ
20.17-
26.4
20.28-
26.4
9.7-
13.2
10.03-
13.2
12VDC @ 9.3A
24VDC @ 9.2A
16
8
2.0
6.3A/250V
5A/250V
15A/
32V
10A/
250V
2A
----
----
2A
T2MK77F16D
20.17-
26.4
20.28-
26.4
20.17-
26.4
20.28-
26.4
24VDC @ 9.2A
16
9
2.0
6.3A/
250V
15A/
32V
10A/
250V
2A
10A/
250V
2A
----
T2MK77F16DQ
20.17-
26.4
20.28-
26.4
20.17-
26.4
20.28-
26.4
24VDC @ 9.2A
16
9
2.0
6.3A/
250V
15A/
32V
10A/
250V
2A
10A/
250V
2A
----
Installation Instructions:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities
having jurisdiction. Product is intended for indoor use only.
1. Remove backplane(s) from enclosure. Do not discard hardware.
2. Mark and predrill holes in the wall to line up with the top three keyholes in the enclosure. Install three upper fasteners and screws
in the wall with the screw heads protruding. Place the enclosure’s upper keyholes over the three upper screws, level and secure.
Mark the position of the lower three holes. Remove the enclosure. Drill the lower holes and install the three fasteners. Place the
enclosure’s upper keyholes over the three upper screws. Install the three lower screws and make sure to tighten all screws.
3. Mount included UL Listed tamper switch (Honeywell Model 112 or equivalent) in desired location, opposite hinge. Slide the
tamper switch bracket onto the edge of the enclosure approximately 2” from the right side
(Fig. 1, pg. 2). Connect tamper switch wiring to the Access Control Panel input or the
appropriate UL Listed reporting device. To activate alarm signal open the
door of the enclosure.
4. Refer to the eFlow Power Supply/Charger Installation Guide (eFlow6NB, eFlow102NB,
eFlow104NB) and Sub-Assembly Installation Guide for the following models:
ACM4CB, ACM8CB, LINQ2, PDS8CB, VR6 for further installation instructions.
5. Fasten snap on standoffs onto metal pems configuration of backplane depending on the
Mercury access controller (Fig. 2-5, pg. 3-6).
6. Position Mercury access controller module over corresponding standoffs and depress onto
snap on standoffs (Fig. 2-5, pg. 3-6).
7. Mount backplane to enclosure with hardware.
Edge of
Enclosure
to Access Control Panel
or U.L. Listed
Reporting Device
Enclosure
Honeywell
model # 112
Tamper Switch
or equivalent
(provided)
Fig. 1
