Altronix STRIKEIT2, Installation Manual

Page: 4 / 8

- 4 - StrikeIt2
LED Diagnostics:
LED LED Status Panic Device Power Controller Status
AC Power Green
On Normal operating condition .
Off Loss of AC .
Red
On 24VDC present on the output (unit is triggered) .
Off Loss of 24VDC on the output (unit is not triggered) .
Maintenance:
Unit should be tested at least once a year for the proper operation as follows:
Output Voltage Test: Under normal load conditions the DC output voltage should be checked for proper
voltage level .
Battery Test: Under normal load conditions check that the battery is fully charged, check specified
voltage both at battery terminal and at the board terminals marked [– BAT +] to
ensure that there is no break in the battery connection wires .
Note: Maximum charging current under discharge is 300mA .
Note:
Expected battery life is 5 years; however, it is recommended changing
batteries in 4 years or less if needed .
Caution: For continuous protection against risk of electric shock and fire hazard, replace input
fuse with the same type and rating 6 .3A/250V . Do not expose to rain or moisture;
indoor use only .
Terminal Identification:
Terminal Legend Function/Description
– AUX + 23 .2-24VDC Auxiliary Output @ 0 .5A .
– BAT + 23 .2-24VDC Stand-by Battery Connection (Two (2) 12VDC batteries wired in series) .
– OUT + Connect 24VDC Panic Hardware Device, up to 16A for 300 ms ., 0 .5A on hold .
GND / NO
Normally Open [NO] trigger input controls output .
A maintained contact closure will extend the unlock period .
Wiring Distance Table:
InRush
Current
Wire Gauge
Electric Butt or Pivot
Max distance from Power Supply
to frame side of opening
EPT
Max distance from Power Supply to
frame side of opening
8A 14 AWG Stranded 75 ft . 100 ft .
8A 12 AWG Stranded 175 ft . 200 ft .
12A 14 AWG Stranded 60 ft . 75 ft .
12A 12 AWG Stranded 80 ft . 100 ft .
16A 14 AWG Stranded 40 ft . 75 ft .
16A 12 AWG Stranded 60 ft . 80 ft .