www.altronix.com
- 8 -
NetWaySP3WP / SP3WPN / SP3WPX / SP3X / SP3PL / SP3B
Wall Mount Installation
1. Mark and predrill holes in the wall to line up
with the top two (2) keyholes in the enclosure.
2. Place unit at desired location and secure with
mounting screws (not included).
Fig. 5
Pole Mounting Using Optional Pole Mount Kit PMK1
(not included)
:
This installation should be made by qualified service personnel. This product contains no serviceable parts. PMK1 is intended for use with Altronix outdoor rated power supplies or
accessories housed in WP1, WP2, WP3, WP4, and WP5 enclosures. Brackets are designed for use with the Wormgear Quick Release Straps (2 included).
1. Thread one (1) wormgear quick release strap through the slots on the back of a mounting bracket (Fig. 6, pg. 8).
2. Once the desired height of the top Pole Mount bracket is achieved, tighten the straps down by sliding open end of the strap through the locking mechanism
on the strap, then tighten the screw with flat head screwdriver or 5/16” hex socket driver (Fig. 7, pg. 8).
3. Attach the bottom bracket to the enclosure by inserting bolts through the flange of the enclosure and into the bracket, tightening bolts with a 7/16” hex socket (Fig. 8, pg. 8).
4. Thread the second wormgear quick release strap through the slots on the back of the bottom mounting bracket (Fig. 9, pg. 8).
5. Mount enclosure onto the top bracket by inserting bolts through flange of the enclosure and into the bracket, tightening bolts with a 7/16” hex socket (Figs. 10 and 11, pg. 8).
6. Tighten the straps of the bottom bracket down by sliding the open end of the strap through the locking mechanism on the strap, then tighten screw with
flat head screwdriver or 5/16” hex socket driver (Figs. 10 and 11, pg. 8).
7. Clip excess straps.
Fig. 10:
Fig. 11:
2” to 8”
5” (127mm) square pole
(50.8mm to 203.2mm)
diameter round pole
Fig. 6
Fig. 7
Fig. 8
Fig. 9
