Installation Instructions:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and
with all local codes and authorities having jurisdiction. Wiring should be UL Listed and/or
Recognized wire suitable for the application.
eBridge1ST is not intended to be connected to outside plant leads and should be installed
indoors within the protected premises. eBridge1ST is intended for indoor use only.
1. Secure unit to the desired mounting surface with a proper fastening device utilizing the case’s
mounting hole (Fig. 2a, pg. 3). Unit should be mounted in proximity of camera/device.
2. Connect structured cable from IP camera/device to RJ45 jack marked [PoE Out]
(Fig. 2 and 3, pg. 3).
3. Connect Coax cable from eBridgePlus receiver (please refer to the list of compatible
receivers on page 1) to BNC tether cable marked [Coax] (Fig. 2 and 3, pg. 3).
Note: This unit is designed to accommodate Megapixel, HD720, HD1080, and VGA (SD) cameras.
It is important to note that some high resolution and high frame rate cameras may demand faster
headend processing ability, such as a PC graphics card, to present a quality image. If the headend
processing equipment’s speed is insufficient, the image may show pixelation and latency. It is
advisable to pretest system if unsure. Alternatively, frame rate and resolution may be reduced to
accommodate system equipment.
Technical Specifications:
Parameter
Description
Connections
BNC for Coax link, RJ45 for camera/device.
Input power requirements
PoE compliant to IEEE 802.3af (15W) and
PoE+ compliant to IEEE 802.3at (30W).
Please refer to the list of compatible receivers on page 1
Indicators
Yellow (RJ45 connector):
On - Link,
Off - No Link, Blinking - Activity.
Green (RJ45 connector):
On - 100Base-TX,
Off - 10Base-T.
Yellow: PoE Active.
Blue: Coax Link is active.
Environmental Conditions
Operating Ambient Temperature: UL60950-1
eBridge1ST:
For 15W: --- 40ºF to 167ºF (---40ºC to 75ºC).
For 25W: - 40ºF to 140ºF (---40ºC to 60ºC).
Relative humidity: 85%, +/ --- 5%
Storage Temperature: --- 40ºF to 167ºF (--- 40ºC to 75ºC).
Operating Altitude: -- 1000 to 6,561.679 ft. (-- 304.8 to 2000m).
Regulatory Compliance
CE approved.
Weights (approx.)
Product: 3.53 oz. (0.1 kg), Shipping: 6.35 oz. (0.18 kg)
Fig. 1
eBridge1ST
Front
Rear
Structured
Cable from
Flying BNC
Connector
Flying BNC
Connector
Green LED
Blue LED
Camera/Device
indicates
indicates
PoE Out
Coax Link
to Device
is active
eBridge1ST
- 2
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]
