- 2 -
ALTV615DC1016 Series Installation Guide
Overview:
ALTV615DC1016 Series DC CCTV Power Supplies provide 6-15VDC distributed via sixteen (16) fuse or PTC
protected outputs for powering CCTV cameras, heaters, and other video accessories.
Sixteen (16) Output ALTV615DC1016 Reference Chart:
Altronix
Model Number
Total
Output
Current
(Power)
Output
Voltage
Number
of
Outputs
PTC
Protected
Outputs
(auto-
resettable)
Fuse
Protected
Outputs
Output
Current
(max. per
output)
115VAC
50/60Hz
Input
Current
ALTV615DC1016
10A
6-15VDC
16
–
P
3.5A
1.9A
ALTV615DC1016CB
10A
6-15VDC
16
P
–
2.5A
1.9A
Specifications:
Input:
• Input 115VAC, 50/60 Hz, 1.9A.
Output:
• Sixteen (16) fuse or PTC protected outputs.
• 6VDC to 15VDC field adjustable.
• 10A total continuous supply current.
• Filtered and electronically regulated outputs.
Features:
• AC input and DC output LED indicators.
• Illuminated power disconnect circuit breaker
with manual reset.
• Unit maintains camera synchronization.
• Ease of installation saves time and eliminates
costly labor.
Enclosure Dimensions
(H x W x D approx.)
:
13.5” x 13” x 3.25”
(342.9mm x 330.2mm x 82.6mm)
Installation Instructions:
1. Mount unit in the desired location. Mark and predrill holes in the wall to line up with the top two keyholes
in the enclosure. Install two upper fasteners and screws in the wall with the screw heads protruding. Place
the enclosure’s upper keyholes over the two upper screws; level and secure. Mark the position of the lower
two holes. Remove the enclosure. Drill the lower holes and install the two fasteners. Place the enclosure’s
upper keyholes over the two upper screws. Install the two lower screws and make sure to tighten all screws
(Enclosure Dimensions, pg. 4)
. Secure enclosure to earth ground.
2. Connect AC power to the two black and two white flying leads of the transformer
(Fig. 1, pg. 3)
.
Units with line cord installed skip Step #2.
3. Plug the line cord into a grounded AC receptacle
(Fig. 1b, pg. 3)
.
4. Adjust output voltage (unit is factory set at 12VDC): use the trimpot on the power supply board
prior to connecting CCTV devices
(Fig. 1a, pg. 3)
.
5. Measure output voltage before connecting devices. This helps avoiding potential damage.
Terminals marked [1P - 16P] are positive (+) and terminals marked [1N - 16N] are negative (–).
CAUTION: Determine the maximum operating voltage of the equipment being powered before
adjusting the output voltage.
6.
Connect devices to terminals marked [1P - 1N] through [16P - 16N] on PD16W/PD16WCB board
(Fig. 1, pg. 3)
,
carefully observing correct polarity.
7. Green LED will illuminate when unit is powered.
8. Upon completion of the wiring, secure enclosure door with screws (supplied).
Caution: Equipment must be installed/serviced by authorized/trained personnel only.
Shut branch circuit power before installing/servicing equipment.
WARNING: To reduce the risk of fire or electric shock, do not expose the unit to rain or
moisture. This installation should be made by qualified service personnel and should
conform to the National Electrical Code and all local codes.
