- 2 -
AL300ULXJ Installation Guide
Overview:
Altronix AL300ULXJ power supply converts a 115VAC, 60Hz input to a 12VDC or 24VDC output.
Features:
Agency Listings:
• UL Listed:
UL294*
Access Control Systems.
UL603
Power Supplies for use with
Burglar-Alarm Systems.
UL1069
Hospital Signaling and
Nurse Call Equipment.
UL1481
Power Supplies for Fire
Protective Signaling Systems.
• cUL Listed:
CSA Standard C22.2 No.205-M1983,
Signal Equipment.
• CSFM
- California State Fire Marshal Approved.
• NFPA 72 Compliant
(Fire-Protective Signaling Service).
Input:
• Input 115VAC, 60Hz, 3.5A.
• Input fuse rated @ 5A/250V.
Output:
• Class 2 Rated power-limited output.
• 12VDC or 24VDC selectable output.
Fire Alarm applications outputs are “Special
Applications”
(refer to Appendix A, pg. 6).
Burglar Alarm Applications (UL 603):
12VDC = 10VDC-13.2VDC.
24VDC = 20VDC-26.4VDC.
Output
(cont’d)
:
• 2.5A total supply current at 12VDC or 24VDC.
Do not exceed total output rating of 2.5A @
12VDC or 24VDC per unit.
• Output fuse rated @ 15A/32V.
• Filtered and electronically regulated output(s).
• Short circuit and thermal overload protection.
LED Indicators:
• AC input, DC output and Battery LED indicators.
Battery Backup:
• Built-in charger for sealed lead acid or
gel type batteries.
• Automatic switch over to stand-by battery
when AC fails.
• Maximum charge current 0.7A.
• Zero voltage drop when switched over to
battery backup.
Supervision:
• AC fail supervision (form “C” contacts).
• Low battery and battery presence supervision
(form “C” contacts).
Additional Features:
• Power supply, enclosure, cam lock and battery leads.
• For grey enclosure add “G” suffix to the part number.
*Access Control Performance Levels:
Destructive Attack - I; Endurance - IV; Line Security - I;
Stand-by Power - IV.
Power Supply Output Specifications:
Output VDC
Switch Position
12VDC
SW1 - ON
(Fig. 1c, pg. 5)
24VDC
SW1 - OFF
(Fig. 1c, pg. 5)
Stand-by Specifications
(total current shown)
:
Output
4 hr. of Stand-by and
5 Minutes of Alarm
24 hr. of Stand-by and
5 Minutes of Alarm
60 hr. of Stand-by and
5 Minutes of Alarm
12VDC / 40AH Battery
Stand-by = 2.5A
Alarm = 2.5A
Stand-by = 1.0A
Alarm = 2.5A
Stand-by = 300mA
Alarm = 2.5A
24VDC / 12AH Battery
–
Stand-by = 200mA
Alarm = 2.5A
–
24VDC / 40AH Battery
Stand-by = 2.5A
Alarm = 2.5A
Stand-by = 1.0A
Alarm = 2.5A
Stand-by = 300mA
Alarm = 2.5A
ON
OFF - 24V
ON - 12V
