1411 S. Roselle Rd. Schaumburg, IL 60193
Phone (847) 923-0002 Fax (847) 923-0004
PerformAIRE PRO
INSTALLATION
Installing RaceWORKS Software
IMPORTANT
:
Do not plug cable into computer until after RaceWorks has been installed
.
1)
Place the
RaceWORKS
CDROM in PC's drive.
2)
Software should Auto Install. If not, Load CD Rom and run SETUP.EXE. Follow instructions on the screen to install
RaceWORKS
software.
3)
To start RaceWORKS program, click on your
START
button
,
go to
PROGRAMS,
go to
RaceWORKS
or click on icon
on the Desktop.
4)
Detailed instructions, as well as videos on using software are available by selecting the
“
Help
” menu icon once program has started.
Mounting System to Trailer
1) PerformAIRE PRO housing features a standard extension pole mount. If you did not purchase an extension pole
with your system, you can use any typical extension pole found at a local hardware or home store. You can supply
your own mounting method to securely affix pole to trailer or use Altronics Part #
ALT-PAPRO-CLAMP
.
2)
It is recommended to keep antenna on bottom of housing at least 3’ from top of trailer.
3) Plug system cable into housing and run cable into trailer. Cable can be ran through trailer access port, door, or
window etc… or use optional bulk head
fitting supplied by Altronics Part #
ALT-PAPRO-CONNECTOR
.
4) Plug cable into USB port on computer.
5) Connect supplied power cable to 12v DC Source (Trailer battery or equivalent), fuse(3 amp fuse).
If a generator is connected to the battery note: Most high end generators provide clean power, if you are unsure we
recommend high voltage transient suppression equipment (noise suppressor) connected in line to avoid "spiking"
transmitter. If you have a 110AC power outlet, an adapter is available to connect to system an eliminate concern for
noisy 12 volt power: Part #
ALT-PAPRO-PGPWR
(Do not use non-specified 110 Power adapter it WILL damage unit!)
Connect 12 volt power to jack in cable connector.
Remote Display
PerformAIRE PRO’s
optional
remote Display Module Part #
ALT-PAPRO-DISPLAY
allows for viewing weather
parameters without requiring system to be connected to a computer. Mount Display Module under cabinet or to
trailer wall. Connect 9 pin connector on system cable to connector on back of Display Module housing. Plug 12 volt
power cable into power jack on back of module. You can also connect Display Module to a computer, plug in USB
cable into USB port on back of Display Module and then into USB port of computer.
Face Direction decal on housing
towards
finish
line
(
Parallel to track).
Top View
With mark aligned properly and wind
vane facing as shown will indicate a
Head Wind.
Track
S
ta
rt
Fi
n
ish
Mark on wind body
Mark on wind body
