14
Service & Maintenance
Washing the machine
V-belt – Checking
1. Remove the protective cover and inspect the V belt.
2. To adjust belt tension, loosen the four engine plate bolts and slide it into position.
3. Tighten the bolts and replace the protective cover.
Washing (high pressure)
Keep the machine clean.
Do not spray water directly on electric components or the instrument panel. Put a plastic bag
RYHUWKH¿OOHUFDSRIWKHIXHOWDQNDQGVHFXUHZLWKDUXEEHUEDQG7KLVZLOOSUHYHQWZDWHUIURP
HQWHULQJWKHYHQWLQJKROHLQWKH¿OOHUFDS7KLVFRXOGRWKHUZLVHFDXVHRSHUDWLRQDOGLVWXUEDQFH
IRUH[DPSOHDFORJJHG¿OWHU
Use only the frame lifting hook (1) to lift the machine.
CAUTION
Control tighten bolts
V-belt
Bolted joints – Check
Check and, where necessary, tighten screws and nuts.
GB
6WRSWKHHQJLQHEHIRUHUH¿OOLQJWKHIXHOWDQN1HYHUUHIXHOQHDUDQRSHQÀDPHRUVSDUNVZKLFKFRXOGVWDUW
D¿UH'RQ¶WVPRNH8VHSXUHIXHODQGFOHDQ¿OOLQJHTXLSPHQW7DNHFDUHQRWWRVSLOOIXHO
WARNING
Never run the machine without the protective cover over the V
belt.
WARNING
Fuel And Lubricants
GB
The bearings in the vibrator housing have been coated with a high temperature grease at the factory. In the event of repair, the bearings
will need the application of grease, which is to be liberally applied to the roller race (but not excessively), before replacement of the covers.
For Maintenance Schedule, please see Page 13.
ENGINE
OIL
Honda:
Use SAE 15W/40 Volume: 0.6 (0.65 qts)
Robin:
Use SAE 10W/30 Volume: 0.6 l (0.65 qts)
Use ordinary grade petrol (unleaded)
FUEL Honda:
Volume: 3.6 l (3.8 qts)
Robin:
Volume: 3.8 l (4.0 qts)
VIBRATOR
Use
SHELL
Stamina EP2 Grease or
HOUSING
Use
TOTAL
Multis Complex EP2 Grease
BEARINGS
