No.
PRESETS
L-OUT/R-OUT LEVEL (±2dbm)
Note
13
DELAY/REV.
-11.0 dbm/-14.0 dbm
14
FLANGE/REV.
XXX
The changed signal (the waveform
strongly changed)
15
CHORUS/REV.
XXX
The changed signal (the waveform
strongly changed)
16
ROTARY
XXX
The changed signal (the waveform
strongly changed)
f. Rotate the “VARIATIONS” (the smaller one) from “1” position, the effect will be changed (it
presents the waveform will be strongly changed), and the “SIGNAL” (red) LED will blink.
g. rotate the “MIX” knob to minimum, connect the AP output to Right Input, at this moment, only
the “R” has output, rotate the “PRESET” (the larger knob) to “Delay” position, and the
“VARIATIONS” (the smaller one) to “1” position, also the “MIX” knob to maximum, the sweep
frequency response curve as below:
h. Test for “BYPASS”: rotate the “MIX” to maximum, connect the footswitch to “BYPASS” jack,
this footswitch can control the DSP effect.
i. When turn off the input signal, the output noise is <-70dbm.
j. Spot-check: to know if there is another noise and the DSP effect is OK.
k. Factory Preset: rotate the “INPUT”, “OUTPUT”, and “MIX” knobs to minimum, the
“VARIATIONS” (the smaller knob) to “1” position, and the “PRESETS” (the larger one) to
“HALL1” position.
- 10 -