13 MAIN
There is the Main Mix Control adjusting the overall volume assigned to the 2
internal speakers or to the MAIN POWER OUT speakers.
14 MAIN LED METER
This 4 segments LED Meter will monitor the volume assigned by the MAIN level
control. If the +10 LED flashes, you have reached the limit of the internal
45+45W amplifier and the outgoing signal is approaching distortion. +10 LED
should flash only occasionally. If no LED is blinking, it means that the output
level is too low, so either you do not hear any music or the signal is too low to
the noise level. For optimal functioning LEDs marked -10 and 0 should always
be blinking.
15 MONITOR
Via this Control, you can adjust the signal
Level applied to the MONITOR OUT sockets.
16 OPERATING
This LED will blink when your PBM4D
SISTEMA is switched ON.
SPO
TLIGHT
4. CONTROL ELEMENTS
13
15
14
16
2
DSP SECTION
Your PBM4D SISTEMA features a 24-bit,
16-presets digital multi-effects including reverbs, chorus, vocal and delay, ect.
Adjust this knob to select the desired
effect.
17 PRESETS
This control is used to adjust the
level of the signal coming from
internal multi-effect .
18 AUX/DFX RET
This switch is used to activate/deactivate the resident multi-effect.
19 DSP MUTE
20
19
PRESETS
DSP
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
AUX/DFX RET
10
0
DSP
MUTE
CLIP
MUTE
1 WARM HALL
2 BRIGHT HALL
3 WARM ROOM
4 BRIGHT ROOM
5 VOCAL 1
6 VOCAL 2
7 VOCAL 3
8 PLATE
9 STEREO DELAY1
10 STEREO DELAY2
11 REV + DELAY1
12 REV + DELAY2
13 REV + DELAY3
14 REV + DELAY4
15 REV + CHORUS1
16 REV + CHORUS2
PRESETS
17
7
18