1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
CH1 MODE SWITCHES CH2
INPUTS
CH1
CH2
CH3 MODE SWITCHES Ch4
Ch3
Ch4
CH3
CH4
BRIDGE
MONO
BRIDGE
MONO
CH2
CH1
INPUTS
AC
INPUT
SERIAL
MODEL
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
BREAKER
OUTPUTS
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10
CH1 MODE SWITCHES CH2
INPUTS
CH1
CH2
CH3 MODE SWITCHES Ch4
Ch3
Ch4
CH3
CH4
BRIDGE
MONO
BRIDGE
MONO
CH2
CH1
INPUTS
AC
INPUT
SERIAL
MODEL
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
BREAKER
OUTPUTS
As to the speaker cable, if you use a long one, use as thick a cable as possible to prevent deterioration of the
damping factor or power loss inside the cable.
Use the following formula to determine the fuse capacity according to the speaker's input capacity.
Po=I R
I=
Po/R
2
Po[W] : Speaker's continuous input capacity (noise or RMS)
R[
] : Speaker's nominal impedance
I[A] : Required fuse capacity
Output
Fuse
(+)
(-)
-
+
Speaker
System
6. CAUTION FOR APPLICATION
6.1 General Application instruction
the following instructions describe the common ways to install your MC700.4 power amplifier into a sound application
system:
First, turn off power switch before connection.
Refer to chapter 5 for speaker connection
MC700.4 power amplifier may be operated in one of the three modes, please slide the mode selector for the
specific operating mode
6.2 caution for speak connection
The output capacity of MC 700.4 power amplifier is very high. Be sure to use a speaker system that has sufficient
input capacity. If the input capacity of your speaker system is lower than the rated output of the MC700.4 power
amplifier, you can protect your speakers by connecting a fuse serially between the speaker and the amplifier
as shown below.
10
