5
3.1.2 BASS PROCESSOR Section
LTO
R
12
EFFECT
AUTO REDUCTION
SENSITIVITY
TUNE
PROCESS
HIGH MIX
SOLO
6
5
0
1
3
2
4
6
5
1
3.3
4.5
2.2
1.5
6
5
0
1
3
2
4
(KHz)
CHANNEL 1
MULTIBAND PROCESSOR
Bypass
EXCITER
ENHANCER
4
5
6
7
8
9
10
4. SOLO Switch
Engaging this switch is used to select the solo mode, and the switch is turned into red. It is used to
mute the original signal from main mix signal.
5. AUTO REDUCTION Switch
Engage this switch to activate the auto reduction function, which is used to reduce the undesired noise
in the system. If releasing the switch, the auto reduction function will have no any effect on the unit, then
the FLEX plus works under the maximum effect, and all EFFECT LEDs will light up.
6. SENSITIVITY Control
In order to achieve the proper effect, you can rotate this control to adjust the sensitivity for input signal
depending on the EFFECT LED display.
7. EFFECT LED Display
These LEDs will inform you the actually effect change and the amount of sound enhancement. The
first LED is always illuminated even at low-level signals.
8. TUNE Control
Through adjusting this control to select the proper cutoff frequency for high pass filter (or low-cut filter,
which is used to reduce or eliminate the frequencies below the cutoff frequency) within a range of 1kHz
to 6kHz.
9. PROCESS Control
Through rotating this control to achieve an increase in apparent loudness in the high frequencies well.
There are two settings: clockwise for enhancer setting; counterclockwise for exciter setting. The only
difference is intensity of increasing between the two settings.
10. HIGH MIX Control
This control is used to adjust the amount of high frequency signal for sound enhancement. It covers a
range from 0 to 6.
3.1.1 MULTIBAND PROCESSOR Section
12
12
INPUT LEVEL (dB)
SHIFT
LOW MIX
6
5
MODE
0
1
3
2
4
ULTRA-LOW
SOFT
NORMAL
BASS PROCESSOR
0
CLIP
LOW
11
12
13
Summary of Contents for FLEX plus
Page 12: ...12 7 BLOCK DIAGRAM ...
