8
- TAPE IN
Use the Tape input if you wish to listen to your mix from
a Tape Recorder or DAT.
- TAPE OUT
These RCA jacks will route the main mix into a tape recorder.
Each channel is equipped with the MUTE switch. Pressing this switch is equal
to turning the fader down, which can mute the corresponding channel output
except for the PRE AUX sends, channel INSERT send.
Abbreviation of PANORAMA control for mono channels, or the stereo channels,
always says, BALANCE control. Keep this control in center position, then the
signal will be positioned in the middle of stage.
Master Section
Inside your APM Series the audio signal is monitored in
several different stages and then sent to the PEAK LED.
When the LED is red illuminated, it warns you that you
are reaching signal saturation and possible distortion, then
you should reduce the input level for avoiding distortion.
18 PEAK LED
Each channel has a PFL switch which will send a signal from a post-EQ pre-fader
location to the PHONES jack. Use this when you wish to use the headphones to
monitor only a specific channel. Moreover, you can monitor a channel no matter
the channel is lowered or the MUTE switch is on when this PFL switch is engaged.
This will not affect the signals that are sent to the ST bus and AUX buses.
17 PFL (pre-fader listen) Switch
SPO
TLIGHT
4. CONTROL ELEMENTS
19 FADER
This fader will adjust the overall level of this channel
and set the amount of signal sent to the main output.
15 PAN/BAL Control
16 MUTE Switch
20 2-TRACK IN/OUT
L
L
R
R
TAPE OUT
2-TRACK IN/OUT
TAPE IN
20
17
18
19
PEAK
PFL
10
dB
5
10
20
25
30
40
60
0
5
1
