# 8 3 1 2 O & C M A N UA L • 7 6 7 - S K / I I I
P G . 8
S E C T I O N 2
C O N T R O L
S E C T I O N 2
Preset Menu Keys:
This Alto-Shaam oven allows the operator to set up to eight cook/smoke programs. Each program can be preset in any
program mode to cook/smoke by time or internal product temperature. Programs are recalled and stored using the P
RESET
Keys labeled "A through H." These keys, along with the key labeled "I", share additional functions described in the "User
Options" section of this manual.
Programming a Cook/Smoke Program
Select the product to be programmed and begin programming with the oven control power O
FF
. Press
and release control O
N
/O
FF
key. The oven will beep for one second and power to the unit will be
indicated by an illuminated green indicator light located in the upper left corner of the O
N
/O
FF
key. The
oven will begin operating in the hold mode. The amber H
OLD
indicator will be illuminated and the last
set hold temperature will be displayed.
P r e s s H
O L D
K e y .
To change the hold temperature, press the U
P
or D
OWN
A
RROW
Key.
Press C
OOK
Key.
Oven preheat indicator will illuminate and the last set cooking temperature is
displayed. To change the cook temperature, press the U
P
or D
OWN
A
RROW
Keys.
To cook by time
— press the T
IME
Key. Last set cooking time is displayed.
To change the set time, press the U
P
or D
OWN
A
RROW
Key. The green T
IME
indicator will illuminate.
To cook by probe
— press the P
ROBE
Key. Last set internal product temperature is displayed.
To change the set temperature, press the U
P
or D
OWN
A
RROW
Key. The green P
ROBE
indicator
will illuminate.
Press S
MOKER
Key.
To set the smoke time desired, use U
P
or D
OWN
A
RROW
key.
The last set
time will be displayed.
The oven preheat indicator will illuminate. Oven is now in the preheat mode and is automatically
programmed to preheat to the cook temperature.
Select a letter code for the product programmed by the previous steps. Press and hold the selected
P
RESET
key until you hear a brief, four second beep. The letter key program indicator light will
illuminate and the product programmed is now stored in memory for the specific letter key pressed.
Additional programs can be stored in the remaining P
RESET
Keys if not previously programmed.
Note:
The last P
RESET
Key used will be the oven cooking run sequence for the next product to be
programmed. Settings can be manually changed for the next product and an alternate pre-programmed
letter key selected.
Erasing a Cook/Smoke Program
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven cannot be
running a P
RESET
Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold both the C
ANCEL
Key and the
appropriate letter P
RESET
Key to be erased. The oven will beep in approximately four seconds and the program's indicator
light will go out to indicate the program has been erased.
IMPORTANT -
After programming a specific product into memory in a programmable
preset key, it is very important to make a written permanent record of the product and
the program letter assigned. Menu card (PE-23384) is provided for this purpose.
—
or
—
ON/OFF
PRESETS
A
